RM3090E _51 Engine / Hybrid System _008397 2AR-FE FUEL _0056276 FUEL PUMP(w/ Canister Pump Module) G

2AR-FE FUEL  FUEL PUMP(w/ Canister Pump Module)  INSPECTION  


PROCEDURE

Hide 23221 1.INSPECT FUEL PUMP

a.

Check the resistance.

i.
A298970
1.083,1.667 1.25,1.667 1.25,1.667 1.573,1.219 true 2.417,1.667 2.25,1.667 2.25,1.667 1.896,1.229 true 0.948,1.583 1.26,1.74 0.313,0.156 10 1 0.104,0.094 0.417,0.25 0.313,0.156 10 *a 2.458,1.583 2.771,1.74 0.313,0.156 10 2
1
*a
2
*a Component without harness connected
(Fuel Pump)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 0.2 to 3.0 Ω


If the result is not as specified, replace the fuel pump.



b.

Check the fuel pump operation.

i.

Connect the positive (+) lead of the battery to terminal 1 of the connector, and the negative (-) lead to terminal 2. Check that the fuel pump operates.

If the fuel pump does not operate, replace the fuel pump.

NOTICE:
·

These tests must be performed within 10 seconds to prevent the coil from burning out.

·

Keep the fuel pump as far away from the battery as possible.

·

Always turn the voltage on and off on the battery side, not the fuel pump side.